Monthly Archives: May 2013

painting a wall

12 Home Repair Tips

Here are twelve great tips for home repair and restoration:

• If you are knocking in a nail on a wall surface that is important, then rougher up the face of the hammer with rough sandpaper to assist the hammer grip the nail and prevent the hammer slipping off the nail when you are knocking it in.

• To fix a hole in a drywall wall after a screw or nail has been removed, make use of a screwdriver which has a rounded end, not a flat end. Press the handle end of the screwdriver into the existing hole that was there. Pushing down creates pressure from the handle and will make a small indentation that is easy to fill in. Fill this indentation drywall compound or spackle and once sanded down, there will be a smooth surface for re-painting.

• When painting a surface that should be topped brand-new drywall or wood colored paint, A good idea to reduce the amount of paint used is to color or tint the primer to match the finish coat, decreasing your painting task from three coats to 2. Most home supply stores will be happy to do this for you.

• If you have to trim a piece of drywall, use a sharp utility knife and score it on both sides before snapping the piece off. After use, the blade may need replacing with a sharper one for a good clean cut. When altering blades in an utility knife, wrap the old cutter in tape prior to you toss it away. When loading down the trash or taking out the garbage, this will coated the sharp edges of the blade to shield from injury.

• After completing your first coat of paint, to save washing out the rollers, wrap all your paint brushes and also rollers in kitchen wrap or plastic from the time you apply coats to keep them loaded with paint and avoid them from getting dry and going hard.

painting a wall

• Do not attempt to deal with electrical or plumbing tasks you are not positive about. It frequently costs even more to fix later and can be hazardous.

• If you want to drill though ceramic tile or even through a natural stone, place duct tape tape on the surface. This will help marking the place to be drilled simpler and helps the drill itself remain in the place where you want to drill down.

• When preparing a budget for a some home improvement project, make sure you add an additional 20% for unexpected surprises. You never know exactly what can happen when you start a new home repair task, often taking out some water damaged wood or panel reveals more work than anticipated.

• If you’re soldering copper in a tight location and you’re a little nervous about burning the house down (never an excellent concept), put a nail plate behind the pipeline so the flame arrives the metal and nothing else.

• See to it you and your whole family know where the major water shut-off valve is located and ways to turn it off in an emergency.

• Setting up a water filter that filters all the incoming water to a house will not only provide you terrific sampling water and of course ice cubes, however it can likewise extend your water fixtures from getting clogged up with grit or small particles saving you lots of expensive plumbing repair work costs!

• To test for correct water pressure you can quickly connect a water-pressure examination gauge to an outdoors sillcock or faucet, Open up the silcock and then on the gauge you can read the water pressure in pounds/sq inch you have in your house. Typical operating water pressure must be around 50 psi – 70 psi. More than 80 psi is thought to be too much water pressure by many building regulations, and can cause water leaks in your home.